Ultra100™ TX2 User Manual
2
General Card Description
The Ultra100 TX2 is designed to support newer motherboards with a PCI bus speed
of 66MHz (versus earlier 33MHz models). The faster bus speed provides up to
266MB per second bandwidth. The card is backward compatible allowing you to
install the controller into a 33MHz PCI bus motherboard where it will allow maximum
data transfers of up to 133MB per second across the bus. Please note that actual
transfer rates will depend on the capabilities of each device attached to the controller.
The controller installs easily into any available PCI slot on your system’s motherboard.
The Ultra100 TX2 controller card provides two IDE channels that support Ultra
ATA/100 protocols, perfect for such demanding applications as real-time video,
multimedia, and high-performance operating systems.
Ultra100 TX2’s two IDE connectors each support a master/slave combination of IDE
devices, including Ultra ATA, EIDE, IDE, Fast-ATA, and ATAPI. Devices of different
standards can be connected to Ultra100 TX2 without performance degradation, due
to the independent programmable timing registers in the controller’s design.
Features
• Provides up to 200MB/sec bandwidth
• CRC checking with Ultra ATA hard drives
• Dual independent channel PCI IDE bus master controller
• PCI “Plug & Play” compatibility
• Coexists with IDE and SCSI controllers
• Onboard BIOS with LBA translation and Extended Int 13, supporting IDE hard
drives up to 128GB
• Flashable BIOS allows easy upgrades
Physical/Environmental
Dimensions
4.81" x 2.82" (12.21cm x 7.20cm)
Operating Temperature
32ºF to 122ºF (0ºC to 50ºC)
Relative Humidity
5% to 95% (non-condensing)
Warranty
Two years limited parts and labor
To Next Page
Loading...
Need help?
General