Ultra100™ TX2 User Manual
12
Installing Drivers with Existing Windows 98
The following section details the installation of Ultra100 TX2 drivers on a system that
has Windows 98 already installed. If you’re installing the Ultra100 TX2 drivers on a
system during a Windows 98 installation, see “Installing Drivers During Windows 98
Installation.”
1. After installing the Ultra100 TX2 controller card and configuring the hard
drives, power up the system and boot Windows.
2. The “Add New Hardware Wizard” will appear, informing you that it has
found a “PCI Mass Storage Controller.”
3. Click on “Next,” and from the generated list box, choose “Search for a
better driver than the one your device is using now.”
4. Click on “Next,” and from the generated choices, choose “Specify a
location.”
5. Type “A:\WIN9X-ME” in the text box that appears.
6. Insert the “Ultra100 TX2 Driver” diskette in drive A:.
7. Click on “Next.” A message informing you that Windows has found “ Win9x-
ME Promise Ultra100 TX2™ IDE Controller” should appear.
8. Click on “Next,” and then on “Finish.”
9. Choose “Yes” when asked if you want to restart your computer. Be sure to
eject the diskette from drive A:.
Confirming Driver Installation in Windows 98
To confirm that the driver has been properly loaded in Windows 98, perform the
following steps:
1. Choose “Settings” from the “Start” menu.
2. Choose “Control Panel,” and then double -click on the “System” icon.
3. Choose the “Device Manager” tab, and then click the “+” in front of “SCSI
controllers.” “Win9x -ME Promise Ultra100 TX2™ IDE Controller” should
appear.
To Next Page
Loading...
Need help?
General