Powering the Dash Cam On / Off
Auto Power On / Off
Once the vehicle engine is started, the dash cam automatically turns on and
starts recording (must have SD Card installed). After the car engine is stopped,
the dash cam will automatically save the last recorded file and shut down.
Note:
Manual Power On / Off
3 seconds to power the dash cam on and off.
Reset the Dash cam
In case the dash cam fails to function normally due to unknown causes, press
the Reset button with sharp pin, then wait for restarting the dash cam. Sometimes
it is also necessary to format the Micro SD Card, which can be performed from
the menu settings.
05
PC 106 HD Dash Cam
Manual Power On / Off and Reset
If your vehicle in car power remains on after the car engine has been turned
off, you may need to remove the car charger, or turn the PC 106 off using
the power button. This is because if the in car power remains on, the
PC 106 will not know that the engine has turned off.
Long press the Power button
Power button
Reset button
To Next Page
Loading...
