Set the Date / Time
To set the correct date and time, press MENU button
to enter the menu setting,
then press and buttons to select Date/Time setting, press OK button to
set it, then press and buttons to adjust the value, press OK button to
switch to next setting, after finished all the settings, press OK button to return
to menu setting, press MENU button to exit menu setting. To start recording
press OK button once.
Mode Selection
The default setting is Video Mode, press MODE button to switch to Still Capture
Mode, then press MODE button to switch to Playback Mode.
Using the Dash Cam
Recording Videos
Before starting to record, please ensure that the Micro SD card (included) is
inserted. If you are using the dash cam for the first time, please format the
Micro SD card at first in the dash cam. Please press OK button to start
recording, the video recording time in red font changes on the screen.
The recorded files are saved to the Micro SD card. To stop recording, press
OK button again. With the car charger connected the dash cam will automatically
turn on and start recording when the car engine starts. When the engine stops,
the dash cam will automatically save the last file and turn off.
www.proofcam.com
06
Note - if your vehicle in car power remains on after the car engine has been
turned off, you may need to remove the power lead, or turn the PC 106
off using the power button. This is because if the in car power remains
on, the PC 106 will not know that the engine has been turned off.
To Next Page
Loading...
