ProofCam PC 106 - Motion Detection; G-sensor Collision Recording Protection; Audio On; Off

Motion Detection
First, press REC/OK button to stop recording; Second, press Menu button to
enter Menu settings to activate the Motion Detection function(the default
setting is Off, press REC/OK button to activate the function); Third, setting the
Auto Power Off to be Off; Fourth, press Menu button to exit Menu settings and
the motion detection icon will appear on the middle upper side of the
screen and standby for detection, it will recording automatically once the dash
cam detects any motion in front of the lens, the recording time is generally
10-15 seconds without any motion is detected again.
The dash cam will start to record next 10-15 seconds if any motion is detected,
press REC/OK button can exit from the motion detection mode and the icon will
disappear from the screen.
NOTES
:
1. When the battery is fully charged and is in good condition, the recording
time depends on the loop recording segment and the default setting is 3 minutes.
2. As the dash cam is used, the battery storage capacity will decrease gradually.
G-sensor Collision Recording Protection
(Protect Level)
When a collision is detected while recording, the lock icon
on the upper middle side of the screen and the current video segment
will be protected automatically (if the collision is detected after the last 5
seconds of this video, the next video will be protected automatically too) and
cannot be replaced.
Audio On / Off
During recording, press DOWN button to turn the microphone on and off.
09
PC 106 HD Dash Cam
will appear
NOTES:
1. The default setting is Low.
2. If the collision happened and you wish to protect the following videos
when the collision is detected before the last 5 seconds of current video,
you can also press KEY button to activate the SOS function during
recording.