PROPAIN HUGENE - ADJUSTING THE SUSPENSION ELEMENTS

A B
1
ďķīÅðāÐðĮÌÐăðŒÐīÐÌœðĴìÅĮðÆÌþķĮĴĉÐĊĴďåĴìÐĮķĮĨÐĊĮðďĊÐăÐĉÐĊĴĮȘÐåďīÐĴìÐťīĮĴīðÌÐșĴìÐðīĨīÐĮĮķīÐðĊĴìÐĮķĮĨÐĊĮðďĊÐăÐĉÐĊĴĮĉķĮĴÅÐÌþķĮĴÐÌĴďřďķīÅďÌřœÐðæìĴȘ
// ADJUSTING THE SUSPENSION ELEMENTS
1. Unscrew the valve cap of the shock / fork.
2. Screw on the shock pump and pump the shock / fork up to the required pressure.
ĺ Observe the instructions for operating the shock pump.
ĺ We recommend a SAG* of 15% - 20% on the fork and 20% - 30% on the shock.
Please pay attention to the manufacturer's instructions of the suspension elements for the air
pressure. The corresponding manuals are included.
3. Unscrew the shock pump and screw the valve cap onto the valve.
* The air pressure of your suspension elements is adjusted via the so-called
SAG (negative travel). The SAG is the degree by which the shock and the fork
ÆďĉĨīÐĮĮÐĮķĊÌÐīĴìÐœÐðæìĴďåĴìÐīðÌÐīȘ}ďÌþķĮĴĴìÐw:șĮðĴďĊĴìÐÅðāÐœðĴì
ăăřďķīÆřÆăðĊæÐĪķðĨĉÐĊĴȧìÐăĉÐĴșÅÆāĨÆāșĮìďÐĮșÐĴÆȘȨĊÌĴāÐĊďīĉă
riding position. No air can escape when unscrewing the shock pump.