ProSun 32/1-P - Assembly Introduction

59
MARK76O0003 Rev 3
Head
Facial
Lamps
Canopy
Feet Bench
Assembly Introduction
Required for assembly (not included):
• 1 wrenches to tighten nuts
• Power adapter kit (230V for commercial use, for warranty to apply voltage must be
between 218-230 V)
*Make sure you write the Serial Number (located on the back of the canopy) down on the
previous page and store the manual somewhere you can easily access. The Serial Number is
MANDATORY to order parts for your unit, as well as, any customer service calls.
The boxes should be shipped in this manner.
Bench
Canopy