ProSun 32/1-P - Electromagnetic Emissions Guidance

29
MARK76O0003 Rev 3
FILL IN STANDARDS INFORMATION HERE
Tanning Bed Standards
Guidance and Manufacturer’s Declaration - Electromagnetic Emissions
The ProSun Onyx Model 32/1-P is intended for use in the electromagnetic environment
speciedbelow.ThecustomerortheuseroftheProSun Onyx Model 32/1-P should assure
that it is used in such an environment
Emmission tests Compliance Electromagnetic environment - Guidance
RF emissions
according to CISPR 11
Group 1 The ProSun Onyx Model 32/1-P uses RF energy
only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
according to CISPR 11
Class A The ProSun Onyx Model 32/1-P is suitable for use in
all establishments excluding domestic establishments
and those directly connected to the public low voltage
power supply network that supplies buildings used for
domestic purposes.
Harmonic emissions IEC
61000-3-2
Not Applicable
VoltageuctuationsIEC
61000-3-3
Not Applicable
This tanning equipment is in conformity with performance standards 21 CFR 1040.20 and the
standards for electromagnetic compatibility (EMC):
IEC 60601-1-2 (2014)