ProSun AquaFrixio - Standby Mode

To Next Page

To Previous Page

MARK68AF1001 Rev 2

Standby Mode

When the unit is in standby mode, you can change the settings and review equipment

specciationsinthesettings.

When the unit is in standby mode the LED decorative lighting can be changes and

customers can set up their massage session prior to starting the session.

You can also enter into the settings when the unit is in Standby mode and go into Service

Mode.

To enter the settings click the top left button in the screen that says, "SETTINGS".

Once in the Settings you can click on the tab you need to change your settings.

• General Tab

• Change to Remote Timer, Stand-Alone or Stand-Alone C Mode. Change the

sessiontime,cooldowntime,watertemperatureandturnonando󰀨QuickStart,

Demo Mode and the general Pin Requirement. You can also change your Pin Code

or password here.

• Region Tab

• Change from Faranheit to Celcius, Change your time zone, Use the 24 hour

clock option, Set the date and time automatically and retrieve the Date and Time

information.

• MyAquaFrixio Tab

• Check for new software updates

• Media Tab

• Turnonando󰀨theStudioandWellnessmusicoption.

• WiFi Tab

• ConnectyourunittotheWinetworkinordertobeconnectedtotheserviceportal

and get the latest updates.

• Manual Mode Tab

• Used for troubleshooting and checking individual components in your unit.

• About Tab

• See your serial number, Software ID code, Massage hours, Session hours and

number of sessions.