Need help?Do you have a question about the Protec 3100 and is the answer not in the manual?
General| Brand | Protec |
|---|---|
| Model | 3100 |
| Category | Control Panel |
| Language | English |
Outlines duties for supervising, testing, and maintaining the fire alarm system.
Verifies system 'Supply Present' indicator and checks for faults.
Tests panel indications, controls, sounders, and call points/detectors.
Includes weekly tests, generator start-up, and battery inspection.
Repeats monthly tests and checks logbook for accuracy and updates.
Tests all detectors, call points, and auxiliary equipment for functionality.
Involves a comprehensive wiring check compliant with national regulations.
Grants general users view-only access to system status and basic functions.
Provides access to critical system functions like silencing and programming.
Procedure to test the integrity of front panel indicators and the internal buzzer.
Signifies a fire detected on any zone or via remote alarm input.
Indicates activation of a Manual Call Point (MCP).
Shows a fire condition in a specific zone, accompanied by General Fire.
Indicates a fire in a zone, which has been acknowledged by muting the buzzer.
Reports faults detected within specific detection zones.
Indicates internal system errors or software malfunctions.
Signals faults in sounder outputs or related circuits.
Detects failures in the main or standby power supply modules.
Reports issues with the monitored fire link communication path.
Indicates a fault with the panel's auxiliary 24V output.
Signals faults with connected 3100 repeat panels or their wiring.
Details the panel's response to automatic detector activation.
Details the panel's response to manual call point activation.
Refers to Section 8.0 for details on delayed alarm activation.
Procedure for silencing alarms and the internal buzzer.
Steps to reset the panel after investigating and resolving an alarm.
Describes panel behavior when a new or previously silenced zone alarms.
How to manually trigger alarms using the 'Sound Alarms' function.
Inhibits faults and fires from specific disabled zones.
Inhibits activations and faults from disabled alarm circuits.
Overrides programmed zone or fire link delays.
Inhibits activations and faults on the fire link output.
Step-by-step guide for disabling detector zones via programming.
Procedure to disable specific alarm output circuits (1-4).
How to override programmed system delays (zonal and fire link).
Steps to disable the fire link interface if it is fitted.
Guides on putting a zone into test mode for simplified detector testing.
Simple instruction to mute the panel's internal buzzer.
Steps to access higher system functions using a code or key.
How to silence active alarms from Access Level 2.
How to manually activate alarms from Access Level 2.
Procedure for resetting the panel after an alarm event.
How to perform a quick test of panel indicators and buzzer.
To Next Page
