Need help?Do you have a question about the Proteco MATRIX and is the answer not in the manual?
Introduction to the Proteco's electromechanical rack-driven motor generation for sliding gates.
Detailed specifications for MATRIX models: power, voltage, thrust, speed, and other key parameters.
Lists the included components and their quantities for the MATRIX gate automation system.
Provides the physical dimensions of the MATRIX gearmotor for installation planning and site assessment.
Explains the types of limit switches (mechanical and magnetic) used for precise gate positioning.
Details the calculation of working cycles based on gate length, weight, and model type.
Explains how to calculate the gearmotor's lifespan based on various influencing factors.
Emphasizes installation by qualified personnel and following chronological order for proper setup.
Lists essential checks for site suitability and component integrity before commencing installation.
Illustrates the electrical connection diagram for various accessories and the main power supply.
Specifies cable types and sizes required for different accessories and power connections.
Details requirements for building a solid concrete basement, including dimensions and reinforcement.
Instructions on how to fix the gearmotor to the ground plate and anchor bolts securely.
Step-by-step guide to unlock the gearmotor for manual gate movement in case of power failure.
Instructions on how to install the toothed rack onto the gate leaf for the gearmotor to engage.
Specific details and fitting instructions for the B102 steel rack, including calibration and welding.
Instructions for installing and adjusting limit switches for precise gate movement and automatic stopping.
Detailed procedure for installing mechanical limit switches and their cams on the rack.
Detailed procedure for installing magnetic limit switches and their cams on the rack.
Guidelines for safe and compliant power and accessory wiring connections to the gearmotor.
Explains how to configure two units for synchronized operation of mirror sliding gates.
Procedures for performing a general test after installation and programming to ensure correct operation.
Steps to fit and secure the main gearmotor cabinet onto the aluminium base.
Procedure to test the efficiency of the manual release system for the gearmotor.
Essential safety advice for users, including keeping children away and proper operation.
Instructions for the end-user on how to manually operate the gate in case of emergency.
Advice for users regarding periodic maintenance and reporting any anomalous behaviors.
Information on how to properly dispose of the system and its packaging according to regulations.
General| Model | MATRIX |
|---|---|
| Category | Gate Opener |
| Power Supply | 230V AC |
| Opening Speed | 12 m/min |
| Closing Speed | 12 m/min |
| Protection Class | IP44 |
| Operating Temperature | -20°C to +55°C |
| Maximum Gate Width | 5 m |
To Next Page
