Proteus PSS-515C - Cable A1 and Pulley Assembly

CABLE A1 AND PULLEY ASSEMBLY
1. SELECT CABLE A1 ( WITH BOLT FITTED IN END ). ONE SIDE IS WITH BIG RUBBER
BALL, AND ANOTHER SIDE IS WITH SMALL BALL AND BOLT.
NOTE : THIS CABLE MUST BE INSTALLED BEFORE PULLEY P1.P2.P3 ARE FITTED.
2. FOLLOW THE DIRECTION IN THE DRAWING, FEED THE BOLT OF CABLE A1
THROUGH THE FRAME AND SCREW INTO THE TOP OF THE PICK-UP POLE ( Q ).
3. FIT PULLEY P1,P2 FIX WITH BOLTS ( 05 ) BUSHINGS ( 21 ) AND NUTS ( 18 ). CHECK
THAT THE CABLE IS SITTING IN THE MIDDLE OF THE PULLEYS.
4. FIT PULLEY P3 ONTO THE PULLEY BRACKET ( V ) AND SECURE WITH BOLT ( 03 )
WASHERS ( 13 ) AND NUT ( 18 ). ( DO NOT OVER TIGHTEN THIS BOLT, THE
PULLEY MUST ROTATE FREELY ).
PULL DOWN A LOOP IN CABLE A1 AND FIT CABLE ONTO PULLEY P3. THEN FIT
CABLE A1 AND PULLEY ( P4 ) ASSEMBLY ONTO TOP TUBE ( A ) WITH BOLT ( 03 )
WASHERS ( 13 ) AND NUT ( 18 ).
14
TOP TUBE
CABLE A1
BIG BALL
CABLE A1
O RING
SMALL BALL
BOLT
LOCK NUT
PICK - UP POLE