Protimeter Grainmaster Page 7
4Setup Mode
The setup mode is entered from the switched – OFF state by pressing while switching
ON using . This action displays the firmware version of the instrument (example 1.00)
until all buttons are released. The product part number (example Grn3000) then scrolls
across the display from right to left followed by the firmware date in yy-mm-dd format
(example 00-06-16) and then the first set up code, 0=0.
The user then has the option of restoring the factory settings (°C, ATC ON, all user crop
adjustments cleared) or simply changing the default setting for the temperature display (°C
or °F) or of enabling/ disabling the automatic temperature correction.
The buttons have the following effects:
• Exit setup mode without any further changes.
• Save any changes and advance to next option
• or Modify the value for the selected option.
Example: To change temperature the display from °C to °F and switch OFF ATC:
1. Press and hold , briefly press , release both buttons.
2. Wait until 0=0 is displayed, press to display 1=0, °C
3. Press to change display to 1=1, °F (Temperatures now in °F)
4. Press to save this change and display 2=0
Table 3: Setup Mode Options
Display Description
0=0 No action
0=1 Resets all user settings to the default settings (°C, ATC ON).
Also resets all user crop adjustments to zero.
1=0 Selects °C for temperature display (accompanied by °C on display)
1=1 Selects °F for temperature display (accompanied by °F on display)
2=0 Activates automatic temperature correction (! in corner cleared)
2=1 Deactivates temperature correction (! displays)
To Next Page
Loading...
Need help?
General
