EasyManua.ls Logo

Protimeter MMS2 User Manual

Protimeter MMS2
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Moisture
INS8800 Rev. D
September 2015
PROTIMETER
A
mphenol
Advanced Sensors
Protimeter MMS2
Instruction Manual
99 Washington Street
Melrose, MA 02176
Phone 781-665-1400
Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
Question and Answer IconNeed help?

Do you have a question about the Protimeter MMS2 and is the answer not in the manual?

Protimeter MMS2 Specifications

General IconGeneral
Measurement ModesPin, Non-Invasive, Humidity, Temperature
Depth of Measurement (Non-Invasive)Up to 3/4 inch (19 mm)
Humidity Measurement Range0% to 100% RH
Temperature Measurement Range-4 to 140 °F (-20 to 60 °C)
Accuracy (Relative Humidity)±2% RH
Accuracy (Temperature)±0.5 °C
DisplayLCD

Summary

Introduction

Safety Considerations

WME Pins and Laser Safety

Safety precautions for WME pins, IR temp, calibration, and laser pointers.

Product Components and Accessories

External Connection Sockets

Details edge and jack sockets (A, B, C) for connecting probes.

Probes and Sensors

Describes various probes (Hygrostick, Surface Temp, Moisture, Hammer) and socket D.

Switching the MMS2 ON and OFF

MMS2 Modes

Pin Moisture Meter - Selection and Use

Guide to selecting and using the Pin Moisture Meter mode.

Pinless Moisture Meter - Selection and Use

Hygrometer - Selection and Use

Psychrometrics - Selection and Use

Condensator Mode

Surface Temperature Probe (Contact Based)

Using the contact-based surface temperature probe for condensation assessment.

Surface Temperature IR (Non-Contact)

Using IR technology for non-contact surface temperature and condensation assessment.

Logging - Selection and Use

Settings - Selection and Use

Set Units

Option to select between Metric and Non-Metric units for measurements.

Date and Time Configuration

How to set the instrument's date and time.

Auto Off Feature

Configuration of the automatic power-off timer.

Set Brightness

Adjusting the display brightness level.

Buzzer On-Off Control

Enabling or disabling the audible buzzer for key presses and alerts.

Set Logging Parameters

Configuring start/end times, sampling intervals, and job numbers for data logging.

Diagnostic Procedure Guidelines

Diagnostic Criteria Table

Outlines three criteria: air-dry condition, surface temp vs. dew point, and salt contamination.

Calibration Checking

Care and Maintenance

Displaying MMS2 Information

Technical Specifications

Operating Conditions

Specifies the operating temperature range and humidity limits for the instrument.

Humidity Measurement Specifications

Provides nominal data for Hygrostick and Short Quikstick humidity and temperature measurements.

Moisture Measurement Specifications

Details specifications for integrated pin, remote pin, and non-invasive (RF) moisture measurements.

Surface Temperature Specifications

Provides specifications for plug-in and IR-based surface temperature measurements.

Physical Specifications

Details power, size, weight, needle depth, and buzzer characteristics.

Regulatory Compliance

Lists compliance certifications such as CE, RoHS, ETL.

User Interface Overview

Describes the keypad and general user interface elements.

Display Specifications

Details the graphical LCD size, resolution, and backlight features.

PC Interface and Data Logging

Describes USB interface, firmware upgrades, setup, and data logging capabilities.

Related product manuals