Protimeter MMS2 User Manual

2 INS8800 Rev. D
Protimeter MMS2 Instruction Manual
• Do not allow children to use laser pointers unless under the supervision of
an adult.
• Use only laser pointers meeting the following criteria:
• Labeled with FDA certification stating “DANGER: Laser Radiation”
for Class 3R lasers or “CAUTION: Laser Radiation” for Class 2
lasers.
• Classified as Class 2 or 3R according to the label. Do not use Class 3b
or Class 4 products.
• Operates at a wavelength between 630 nm and 680 nm.
• Has a maximum output less than 5 mW, the lower the better.
3. Product Components and Accessories
The MMS2 instrument measures the different parameters in the buildings:
room temperature, room humidity, building material moisture, surface
moisture and surface temperature (contact and non-contact method). To
measure all the above mentioned parameters, MMS2 uses different sensors,
along with a variety of accessories for convenient measurements. The
following external connections are found on the instrument (see Figure 1 on
page 3):
A - This edge connection socket is for use with a Hygrostick
®
Quikstick or
Short Quikstick probe.
B - This jack connection socket is for use with a moisture probe, deep wall
probes or a Hammer electrode.
C - This jack connection socket is for use with the Direct Contact Surface
Temperature Sensor.

Protimeter MMS2 Specifications

General

Measurement Modes	Pin, Non-Invasive, Humidity, Temperature
Depth of Measurement (Non-Invasive)	Up to 3/4 inch (19 mm)
Humidity Measurement Range	0% to 100% RH
Temperature Measurement Range	-4 to 140 °F (-20 to 60 °C)
Accuracy (Relative Humidity)	±2% RH
Accuracy (Temperature)	±0.5 °C
Display	LCD