Protimeter MMS2 User Manual

10 INS8800 Rev. D
Protimeter MMS2 Instruction Manual
4.2 Pinless Moisture Meter — Selection and Use (cont.)
In Search mode, the device has the capability to give comparative
measurement.
Note: If metal is present below the surface, the MMS2 may give a false
positive.
Comparative measurement helps in measuring whether the surface
moisture/material is wetter or dryer than the Reference surface/ material. If
the surface moisture/material is wetter than the reference surface/ material,
then the progress bar is red, or if it’s dryer, then the progress bar is green.
This method takes four steps:
1. Select
Pinless Moisture meter under the Main Menu.
2. Place the device on the material which has been chosen as the reference
material.
3. Press the right arrow button for two seconds to store the reading as
reference reading.
4. Now if the device is placed on any material, it indicates whether the
material is wetter or dryer than the reference material.
4.3 Hygrometer - Selection and Use
Navigate to SELECT MODE -> HYGROMETER and press to select the
Hygrometer mode.
To use the Protimeter MMS2 as a Hygrometer (see Figure 4 on page 11),
connect the Hygrostick, Quikstick or Short Quikstick probe into socket
A
either directly or indirectly with the extension lead.

Protimeter MMS2 Specifications

General

Measurement Modes	Pin, Non-Invasive, Humidity, Temperature
Depth of Measurement (Non-Invasive)	Up to 3/4 inch (19 mm)
Humidity Measurement Range	0% to 100% RH
Temperature Measurement Range	-4 to 140 °F (-20 to 60 °C)
Accuracy (Relative Humidity)	±2% RH
Accuracy (Temperature)	±0.5 °C
Display	LCD