Protimeter MMS2 User Manual

INS8800 Rev. D 17
Protimeter MMS2 Instruction Manual
4.7b Date and Time
Navigate to SELECT MODE -> SETTINGS -> DATE AND TIME and press to
change the date and time. Use to navigate to the required field. Then, use
/ to increment/decrement the value in that box.
After entering the required date and time, press to set the date and time.
The new date and time are displayed at the top right corner of the screen. Date
and time can also be set up by connecting to a PC and using the optional
MMS2 logging software.
4.7c Auto Off
The MMS2 will switch OFF automatically after auto switch off time, if no
activity/key press is observed. Navigate to
SELECT MODE -> SETTINGS ->
AUTO OFF and press to configure the Auto off time. Use / to
navigate between 0 to 6 minutes and press to set the Auto off time. To
disable the Auto off feature, set the Auto switch off time to 0.
Note: During continuous logging operation, auto switch off time is
considered to be the display turnoff time.
4.7d Set Brightness
Navigate to SELECT MODE -> SETTINGS -> SET BRIGHTNESS and press to
set the Brightness level. Use / to navigate between the different
brightness levels (1 to 10) and press to set the desired brightness.
(Brightness level 2 is the default setting.)

Protimeter MMS2 Specifications

General

Measurement Modes	Pin, Non-Invasive, Humidity, Temperature
Depth of Measurement (Non-Invasive)	Up to 3/4 inch (19 mm)
Humidity Measurement Range	0% to 100% RH
Temperature Measurement Range	-4 to 140 °F (-20 to 60 °C)
Accuracy (Relative Humidity)	±2% RH
Accuracy (Temperature)	±0.5 °C
Display	LCD