3
Setting Up the Display
The display requires a stable, level, and clean surface near a power outlet, 10 cm (4") away from
walls or other large objects. The rear ventilation grid should be unobstructed, and the display
should not be exposed to water or heat. Before setting up the display, prepare such a space.
To set up the display:
1. Remove the protective plastic bag and plastic screen protector from
the display.
2. Remove the power cord from the accessories box, insert the
appropriate end into the power (AC IN) connector on the bottom of
the display, and then insert the other end into a free power outlet.
3. Turn on the power switch on the bottom of the display.
Connecting to a TV Signal Source
A TV signal may come from a cable box, satellite receiver,
antenna, or similar device.
To connect a TV signal source to the display:
1. Remove the coax-to-RCA adapter from the Accessories Box
and insert it into the antenna (ANT) jack on the bottom of
the display.
2. Connect a coax cable between the adapter and TV signal
source (for example, a cable box, satellite receiver, or antenna).
Note: If you would like to be able to record
the TV signal with a VCR, DVD
recorder, or similar device, connect
the TV signal source to the input of
the recording device with one cable,
then connect the output of the
recording device to the ANT jack on
the display with another cable.
OMPLTV32C.book Page 3 Thursday, June 2, 2005 9:07 AM
To Next Page
Loading...
Need help?
General
