Need help?Do you have a question about the Proview UK513 and is the answer not in the manual?
Covers reading instructions, placement, ventilation, and cleaning.
Addresses grounding, preventing electrical hazards, and when to seek professional service.
Key general specifications of the monitor panel and overall device.
Details the pin assignments for the D-SUB signal connector.
Details horizontal and vertical timing parameters for different resolutions.
Procedures for checking power supply and power saving modes.
Steps to enter factory mode, auto-adjust, and configure OSD settings.
Diagnostic steps for when the display shows no output but is powered on.
Initial checks involving power supply, voltage, and board connections.
Steps involving control cable and main board voltage checks.
Verifying main board input voltage and 5.0V supply.
Verifying 3.3V and 1.8V inputs to the main board.
Checking H/V input signals and final display output.
Diagnostic steps for when the display shows white but no image.
Steps to check 5V and 3.3V supply on the main board.
List of various resistors and resistor networks with their specifications.
List of capacitors and varistors used in the device.
List of diodes, transistors, MOSFETs, and crystals.
List of fuses, connectors, cables, and panel components.
Specific jumper wires and 0805 chip resistors with their locations.
List of 1206 chip resistors and their corresponding positions on the board.
More chip resistors in 1206 and 0805 packages with details.
List of chip resistors and various types of capacitors.
Details on varistors, MOF resistors, and high-voltage capacitors.
Listing of high voltage and chip capacitors with specifications.
Various types of diodes and bridge diodes.
Components including Zener diodes, transistors, and MOSFETs.
PWM controllers, opto couplers, and voltage regulators.
Transformers, fuses, connectors, labels, and glue.
Shows input signals like VGA, Hsync, Vsync, SDA, SCL.
Details connections between control board, LCD panel, and audio.
Shows power supply connections and CCFL backlight control.
Exploded view showing placement of PCBs and internal parts.
Details of external parts like front panel, rear cabinet, and base.
Notes on changes and updates made to various schematics.
Detailed circuit layout of the power board, including voltage regulation.
Circuit details for DVI signal processing and ESD protection.
Circuitry for VGA input signals including Hsync, Vsync, R, G, B.
Circuit details of the scaler IC, including LVDS output and power supply.
Details the LVDS signal connections to the LCD panel.
Circuitry for the MCU, keypad input, and LED control.
Specific components and their placement on the power board.
Detailed circuit connections and component values for the power supply.
Visual layout of major components on the main PCB.
Component layout for the top layer of the Power Board.
Component placement on the bottom layer of the Power Board PCB.
To Next Page
General