ORiNOCO
®
802.11n Access Points - Software Management Guide 124
Figure 7-5 Wireless Interface 1 Rogue Scan Statistics
The Rogue Scan Statistics screen, contains the following information:
Click Refresh, to view the updated Rogue Scan Statistics and click Clear, to clear the Rogue Scan Statistics.
Parameter Description
SSID Specifies the SSID of the detected device.
MAC Address
(BSSID)
Specifies the MAC address of the detected device.
Device Type Specifies the device type (AP, STA, Adhoc, WDS and other devices) detected.
Channel Specifies the channel of the detected device.
Security Specifies the security applied on the detected device. Tabulated below are different Security
types and the corresponding Authentication Modes / Encryption Types applied on the device.
TSLF Specifies the time period since the last frame is received (TSLF) over the channel. It is
recorded in dd : hh : mm : ss (days: hours: minutes: seconds)
RSSI Specifies the strength of the signal received by the detected device. The signal strength
detected by the device, varies between 0 - 128. The higher the value, the greater is the
received signal strength.
Security Encryption Type /
Authentication Mode
None No security
WEP WEP / Dot1x
WPA PSK-TKIP / Dot1x TKIP
WPA2 PSK-AES / Dot1x AES
Other / WEP Other
To Next Page
Loading...
Need help?
General
