ORiNOCO
®
802.11n Access Points - Software Management Guide 125
7.4 Bridge
The device serves as a bridge between the wired and the wireless networking devices.
7.4.1 Bridge Statistics
The Bridge Statistics allows you to monitor the statistics of the Bridge.
To view bridge statistics, navigate to MONITOR > Bridge > Bridge Statistics. The Bridge Statistics screen appears.
Figure 7-6 Bridge Statistics
The Bridge Statistics screen contains the following information:
Parameter Description
Description Specifies the interface type that is ‘Bridge’.
Type Specifies the type of interface that is distinguished according to the physical/link protocol(s)
below the network layer in the protocol stack.
MTU Specifies the largest size of the data packet sent on the bridge.
Physical Address Specifies the MAC address of the interface.
Operational Status Specifies the current operational status of the bridge.
In Octets Specifies the total number of octets received on the bridge.
In Unicast Packets Specifies the number of unicast sub-network packets delivered to the higher level protocol.
In Non-Unicast
Packets
Specifies the number of non-unicast sub-network packets delivered to the higher level
protocol.
In Errors Specifies the number of inbound packets with errors and that are restricted from being
delivered. In Errors on the wireless interface include CRC errors.
To Next Page
Loading...
Need help?
General
