ORiNOCO
®
802.11n Access Points - Software Management Guide 54
Authentication
Mode
: When multiple VAPs are enabled on the AP device, then no two security profiles
with WEP authentication, should be enabled at the same time.
c. PSK (Pre-Shared Key): Select PSK from the Authentication mode drop down menu
and the configuration screen appears:
Figure 5-18 PSK Authentication Mode
Configure the following parameters in PSK Authentication Mode:
Configure the following parameters in WEP authentication mode:
Parameter Description
Key This parameter allows you to configure the WEP key for
the wireless security. Enter a WEP Key in the Key box.
– For 64-bit encryption, an encryption key is 10
hexadecimal characters (0-9 and A-F) or 5 ASCII
characters. See ASCII Character Chart.
– For 128-bit encryption, an encryption key is 26
hexadecimal characters or 13 ASCII characters.
– For 152-bit encryption, an encryption key is 32
hexadecimal characters or 16 ASCII characters.
: Special characters - = \ " '? / space are not
allowed while configuring the WEP key.
To Next Page
Loading...
Need help?
General
