Proxim Tsunami MP-8100 Series - Page 20

Command Line Interface
Tsunami MP-8100 Reference Manual 20
Primary DNS, Secondary DNS, and Supported Interfaces
Supported Interfaces Scalar is a read-only parameter, and it displays the interface names that are supported on the device
depending upon the Network Mode (Bridge/Router) in which the device is running. To configure Primary/Secondary Domain
Name Servers on the device, use the following commands.
Radio Mode Configuration
The device supports two modes, BSU and SU.
System Name(config)# network
System Name(config-net)# flush-arptable no
System Name(config-net)# primary-dns-ip 172.18.18.23
System Name(config-net)# secondary-dns-ip 169.234.127.12
System Name(config-net)#exit
System Name(config)#exit
DNS servers configuration and supported interfaces on the device can be shown using the
following Command:
System Name# show network netconfig
// NETCONFIG CONFIGURATION //
Flush ARP Table : no
All Interfaces Default Router Address : 192.168.2.1
Supported Interfaces : br0
Primary DNS Ip Address : 172.18.18.23
Secondary DNS IP Address : 169.234.127.12