Proxim Tsunami MP-8100 Series - Page 21

Command Line Interface
Tsunami MP-8100 Reference Manual 21
Country Code, Network Mode, and Frequency Domain Configuration
The device can operate in two network modes, they are
• Bridge Mode
System Name(config)# radio-mode
System Name(config-radio)# ?
Possible completions:
exit Exits Back to Global Configure Mode
interface Radio Mode Index
System Name(config-radio)# interface 1 ?
Possible completions:
<[Enter]> Execute this command
radio-mode Configure the mode of the radio(s)
System Name(config-radio)# interface 1 radio-mode
% Input Range <ap(1),client(2),wds(3),bsu(4),endPointa(4),su(5),endPointb(5)..Plz refer the
Supported mode radio mode(s).> required
Note: Here you have to configure the radio mode as endPointa or endPointb.
System Name(config-radio)# interface 1 radio-mode 4
Changes in Radio Mode requires Reboot
Changes in Radio Mode resets the Wireless and WORP parameters to default values
System Name(config-radio)#exit
System Name(config)#exit
System Name# show system-type
// SYSTEM COUNTRY CODE,PACKET FORWARD MODE CONFIGURATION //
Forwarding Mode : bridge
Active Network Mode : bridge
// SYSTEM TYPE CONFIGURATION //
RADIO-INDEX 1
Radio Mode : EndPointA
Active Mode : EndPpintA
Supported Radio Modes : EndPointA<4>,EndPointB<5>
Supported Frequency Domains : 4,9,10,11,13,14,15,6,7,8,12,5
Frequency Domain : taiwan5ghz
Active Frequency Domain : taiwan5ghz