Proxim Tsunami MP-8100 Series - Page 30

Command Line Interface
Tsunami MP-8100 Reference Manual 30
Security Radius Supported Table
Enter the following command to configure the Security Radius Supported table entries.
1.5.4.6 Wireless Security
Enter the following command to configure a Security-Wireless Config table entries.
Example
System Name(config)# radius
System Name(config-rad)#supported-table
System Name(config-rad-supported)# rowedit 1 entry-status enable
System Name(config-rad-supported)# rowedit 1 max-retransmissions 3
System Name(config-rad-supported)# rowedit 1 mes-response-time 3
System Name(config-rad-supported)# rowedit 1 re-authentication 0
System Name(config-rad-supported)# rowedit 1 profile-name defaultradius
System Name(config-rad-supported)#exit
System Name(config-rad)#exit
System Name(config)#exit
System Name# show security radius-supported
// RADIUS SUPPORTED TABLE CONFIGURATION //
INDEX 1
Profile Name : Default Radius
Max Retransmissions : 3
Message Response Time : 3
Re Authentication Period : 0
Entry Status : enable
System Name (config)#security
System Name (config-sec)#wireless-config-table
System Name (config-sec-tbl)#rowadd 0 authentication-mode worp
System Name (config-sec-tbl)#rowadd 0 encryption-type wpa2-aes
System Name (config-sec-tbl)#rowadd 0 entry-status enable
System Name (config-sec-tbl)#rowadd 0 key-index 4
System Name (config-sec-tbl)#rowadd 0 key1 ~!@#$%^&*()_+|{}
System Name (config-sec-tbl)#rowadd 0 key2 ~!@#$%^&*()_+|{}
System Name (config-sec-tbl)#rowadd 0 key3 ~!@#$%^&*()_+|{}
System Name (config-sec-tbl)#rowadd 0 key4 ~!@#$%^&*()_+|{}
System Name (config-sec-tbl)#rowadd 0 network-secret public
System Name (config-sec-tbl)#rowadd 0 profile-name Security1
System Name# show security wireless-config
// SECURITY WIRELESS CONFIG TABLE CONFIGURATION //
INDEX 1
Profile Name : WORP Security
Authentication Mode : worp
Key Index : four
Encryption Type : wpa2-aes
Entry Status : enable
Network Secret : ******
key 1 : ******
Key 2 : ******
Key 3 : ******
Key 4 : ******
INDEX 2
Profile Name : Security1
Authentication Mode : worp
Key Index : four
Encryption Type : wpa2-aes
Entry Status : enable
Network Secret : ******
key 1 : ******
Key 2 : ******
Key 3 : ******
Key 4 : ******