Proxim Tsunami MP-8100 Series - Basic Configuration Information

Command Line Interface
Tsunami MP-8100 Reference Manual 40
Transparent Mode
Trunk Mode & VLAN Trunk Table
The following commands are used to configure the VLAN Trunk table. It is configurable only in bridge mode.
For Ethernet Interface 1
System Name(config-vlan)# config-table
System Name(config-vlan-configtbl)# rowedit 1 vlan-mode access
Note: Vlan Mode can be configured as Access only when Device is running in SU
mode.Transparent & Trunk Mode can be configured in both BSU & SU modes
Access Vlan Id & Access Vlan Priority are Access Mode Related Parameters.The Commands for
these parameters are as follows:
System Name(config-vlan-configtbl)# rowedit 1 access-vlan-id 23
System Name(config-vlan-configtbl)# rowedit 1 access-vlan-priority 3
Command For Configuring Untagged Frames:
System Name(config-vlan-configtbl)# rowedit 1 untagged-frames 1
Similarly the Parameters can be configured on Ethernet Interface 2 by mentioning interface
number as 2 :
For Example :
The following Command is for configuring vlanmode on Ethernet Interface 2:
System Name(config-vlan-configtbl)# rowedit 2 vlan-mode access
System Name# show vlan
// VLAN CONFIGURATION //
Vlan Status : enable
MgmtVlan Id : 234
MgmtVlan Priority : 0
// VLAN Ethernet Configuration //
INDEX 1
Vlan Mode : access
Access Vlan ID : - 23
Access Vlan Priority : 3
Allow Untagged Frames : enable
System Name(config-vlan-configtbl)# rowedit 1 vlan-mode transparent
System Name(config-vlan-configtbl)# rowedit 1 vlan-mode trunk
System Name(config)# vlan
System Name(config-vlan)# trunk-table
System Name(config-vlan-trunk)# rowadd 1 secondary-index 0 entry-status create
System Name(config-vlan-trunk)# rowadd 1 secondary-index 0 trunk-id 10
System Name(config-vlan-trunk)# rowadd 1 secondary-index 0 entry-status create