Proxim Tsunami MP-8100 Series - Page 41

Command Line Interface
Tsunami MP-8100 Reference Manual 41
For Ethernet Interface 2
Vlan Trunk Table
The following commands are used to show the VLAN Trunk table. It is configurable only in bridge mode.
For Ethernet Interface 2:
System Name(config)# vlan
System Name(config-vlan)# trunk-table
System Name(config-vlan-trunk)# rowadd 2 secondary-index 0 entry-status create
System Name(config-vlan-trunk)# rowadd 2 secondary-index 0 trunk-id 10
System Name(config-vlan-trunk)# rowadd 2 secondary-index 0 entry-status create
System Name# show vlan-trunk
// VLAN TRUNK TABLE CONFIGURATION //
INDEX 1.1
Trunk ID : 10
Entry Status : enable