Proxim Tsunami MP-8100 Series - 4 Advanced Configuration

Command Line Interface
Tsunami MP-8100 Reference Manual 44
Pir List Configuration
System Name(config-worpqos)# pir-list
System Name(config-worpqos-pirlist)# ?
Possible completions:
exit Exits Back to Global Configure Mode
rowadd Enter 0 to create a new table entry
rowedit Enter row number to edit/delete
System Name(config-worpqos-pirlist)# rowadd 0 ?
Possible completions:
<[Enter]> Execute this command
rule-bit-mask Enter the Rule Bit Mask Value
entry-status Table Entry status
ether-priority-high Ether Priority High Configuration
ether-priority-low Ether Priority Low Configuration
ether-priority-ruleEnable/Disable Ethernet Priority
ether-type Ether Type Configuration
ether-type-ruleETHERNET TYPE Rule Configuration
ether-value Ether Value Configuration
pir-name Rule Name Configuration
pppoe-encapsulation PPPoE Encapsulation Configuration
pppoe-protocol-id PPPoE Protocol ID Configuration
protocol-ids Protocol Configuration
tos-high ToS High Configuration
tos-low ToS Low Configuration
tos-mask Tos Mask Configuration
tos-rule TOS Rule Configuration
vlan-id Vlan Id Configuration
vlan-rule VLAN Rule Configuration
System Name(config-worpqos-pirlist)# rowadd 0 entry-status 4
System Name(config-worpqos-pirlist)# rowadd 0 rule-bit-mask 2047
System Name(config-worpqos-pirlist)# rowadd 0 ether-priority-high 5
System Name(config-worpqos-pirlist)# rowadd 0 ether-priority-low 5
System Name(config-worpqos-pirlist)# rowadd 0 ether-priority-rule enable
System Name(config-worpqos-pirlist)# rowadd 0 ether-type dix-snap
System Name(config-worpqos-pirlist)# rowadd 0 ether-type-rule enable
System Name(config-worpqos-pirlist)# rowadd 0 ether-value 00:00
System Name(config-worpqos-pirlist)# rowadd 0 pir-name 802.1p
System Name(config-worpqos-pirlist)# rowadd 0 pppoe-encapsulation enable
System Name(config-worpqos-pirlist)# rowadd 0 pppoe-protocol-id 2:2
System Name(config-worpqos-pirlist)# rowadd 0 protocol-ids 0
System Name(config-worpqos-pirlist)# rowadd 0 tos-high 0
System Name(config-worpqos-pirlist)# rowadd 0 tos-low 0
System Name(config-worpqos-pirlist)# rowadd 0 tos-mask 0
System Name(config-worpqos-pirlist)# rowadd 0 tos-rule enable
System Name(config-worpqos-pirlist)# rowadd 0 vlan-id 1002
System Name(config-worpqos-pirlist)# rowadd 0 vlan-rule enable
System Name(config-worpqos-pirlist)# rowadd 0 entry-status 4
System Name(config-worpqos-pirlist)#exit
System Name(config-worpqos)#exit
System Name(config)#exit
System Name#
System Name# show worp-qos pir-list
INDEX 1
Rule Name : 802.1p
Bit Mask : 2047
ToS Rule : enable
ToS Low : 0
ToS High : 0
ToS Mask : 0
Ether Priority Rule : enable
Ether Priority Low : 5
Ether Priority High : 5
VLan Rule : enable
Vlan Id : 1002
PPPoE Encapsulation Status : enable
Ether Type Rule : enable
Ether Type : dix-snap
PPPoE Protocol ID : 2:2
Ether Value : 00:00
Protocol Ids : 0
Map Table Index Value : 1
Entry Status : enable