Proxim Tsunami MP-8100 Series - Page 52

Command Line Interface
Tsunami MP-8100 Reference Manual 52
1.5.5.2 Access Table
1.5.5.3 Access Table Status
1.5.5.4 HTTP
System Name(config-mgmt)# access-table
System Name(config-mgmt-tbl)# rowadd 0 entry-status 4
System Name(config-mgmt-tbl)# rowadd 0 ipaddress 10.0.0.1
System Name(config-mgmt-tbl)# rowadd 0 entry-status 4
System Name(config-mgmt)# access-tbl-status enable
System Name(config-mgmt)#exit
System Name(config)#exit
System Name# show access-ctrl
// ACCESS CONTROL CONFIGURATION //
All Access Control : enable
Http Access Control : enable
Https Access Control : enable
Snmp Access Control : enable
Telnet Access Control : enable
SSH Access Control : enable
Mgmt Access Status : disable
// Management Access Table Configuration //
INDEX 1
Ip Address : 10.0.0.1
Status : enable
Perform the following commands to configure the http password, port number for Telnet.
System Name# configure
System Name(config)# management
System Name(config-mgmt)# http
System Name(config-mgmt-http)# password public123
System Name(config-mgmt-http)# port 123
System Name(config-mgmt-http)#exit
System Name(config-mgmt)#exit
System Name(config)#exit
System Name# show http
// HTTP CONFIGURATION //
Password : ******
Port : 123