HEALTH & SAFETY
Marktronic Marker
This covers essential health and safety of the Marktronic Marking machine. It is
intended to supplement and support the training given by the suppliers of the
equipment and the operation manuals.
Weight of Machine and Ancillary Equipment
BenchDot300-150ZA Marking Unit
54Kg
inc. Base and Column
BenchDot150-150ZA Marking Unit 44Kg
inc. Base and Column
BenchDot100-100ZA Marking Unit 40Kg
inc. Base and Column
MarkMate Marking Unit 13Kg
Inc. Base and Column
Marking Controller 7Kg
Circumferential Fixture 10Kg
Magnetic Chuck 10Kg
The weights quoted are approximate.
Handling
Care must be taken when moving or handling not to drop the equipment, causing
damage to operators or other persons handling the machinery. It is advisable when
lifting the machine to have two people to lift, using the base and column, it must not
be lifted by the cover.
Noise Emissions
Depending on the nature of the workpiece and any support required noise emitted
by the machine when marking may exceed 70dB(A)Leq. Where it is established
that noise emissions may exceed current regulations, noise control methods (eg. ear
defenders/machinery guards) should be utilised.
Electrical Hazards
To prevent electrical shock do not remove the cover of the controller or marking
head. There are no user serviceable parts inside. Refer servicing to qualified
service personnel. Only connect the controller to the correct supply voltage. This is
clearly marked on the rear of the controller.
To Next Page
