56
WARNING:
1. REFER TO THE RATING PLATE FOR THE PUMP PRESSURE AND THE NOZZLE TYPE.
2. REFER TO THE OIL BURNER’S INSTRUCTIONS MANUAL FOR DETAILS ON THE PUMP.
3. FOR ELECTRODES SETTING, SEE THE OIL BURNER’S MANUAL.
4. FOR THE START-UP AND ADJUSTMENT OF THE BURNER, SEE THE INSTRUCTIONS MANUAL OF
THE BURNER.
5. IN CASE OF BURNER FAILURE, REFER TO THE BURNER MANUAL.
4- APPLIANCE START-UP
The start-up must be performed by a qualified technician. Make sure the installation is completed and the oil tank has
been filled up. The oil line must also have been purged.
5- PROLONGED CLOSING
A) Cut off the electric circuit
B) Close the oil shut-off valve
NOTE: THE SHUT-OFF VALVE MUST BE CLOSED WHEN THE APPLIANCE IS OUT OF SERVICE FOR A
PROLONGED PERIOD OF TIME.
6- MAINTENANCE
At the beginning of heating season, have the complete installation inspected by a qualified service man, especially the
lighting system and the controls.
SERVICE
Before calling for service, first check the following:
- Fuel supply
- Electric fuses or breakers
- Thermostat setting
- PC board settings
- The state of the green diagnostic LED on the burner control.
CAUTION: CLOSE THE BLOWER COMPARTMENT ACCESS
PANEL BEFORE STARTING THE BURNER.
NOTE: THE UNIT’S MAINTENANCE, REPAIRS AND THE CLEANING OF
THE OIL FILTER MUST BE DONE BY A QUALIFIED TECHNICIAN.
To Next Page
Loading...
