VP Keypad Access Device
22
114A3868.E rev. 7-2017
Optional Setup Functions
At this point, the basic parameters required for operation have been
entered. If no other options are active or required, you can exit the
setup mode. Following are optional parameters to customize the
feel of the site.
Setup Password
* =Change #=No
Change the setup password from the factory default of 8898.
When
YES is selected, the unit will prompt for the new password.
The new password must be entered twice for verification before
it changes, if both entries match, the password will be changed.
Otherwise, a message will indicate that the passwords do not
match.
Tamper Switch:
Disabled
Controls the use of the tamper sensor. If enabled, the keypad will
not function and an alarm will occur from the controller if the unit is
tampered with. Factory default is Enabled.
Secure Entry
Disabled
Controls the characters displayed during code entry. When set
to Enabled, the display will show only an X for each key pressed.
When set to Disabled, the numbers pressed will be echoed to the
display. Factory default is Disabled.
Beep with Key
Enabled
Controls the internal buzzer used to provide audio feedback for
any key press. When set to
Enabled, the buzzer will produce a
short beep when a key is depressed. When set to
Disabled, the
buzzer will not sound with key presses. Factory default is Enabled.
To Next Page
Loading...