VP Keypad Access Device
29
rev. 7-2017 114A3868.E
Trip Relay Offline Check — After the customer has entered their
code, the VP checks to see if the
Trip Relay NoCom option
has been enabled. If it has been enabled and the keypad is not
in communication with the controller, then the VP will display the
following message and further access attempts will be allowed.
Access Granted
Access Response Messages
There are several standard messages built in to the VP. The types
of messages the VP receives in response to an access request vary
depending on the conditions. The following briefly describes the
conditions and the displayed message.
For a valid Entry:
* Welcome *
Entry Is Granted
For a valid Exit:
* Thank You *
Exit is Granted
When the area is closed (outside of allowed time zone hours):
Sorry –
Area Closed
When the customer is not authorized to enter an area:
Sorry –
Area Denied
To Next Page
Loading...