FR
ES
EN
DE
IT
8
2.!$/$0%.0,$#!6 - //0.4$#5.0*1'./
L2
L3
' -&(-&2'$%.05 0# -#0$4$01$&$ 0" !+$1
#)312(-&2'$%.05 0# -#0$4$01$&$ 0" !+$1 -#2'$
!+ #$"+32"'" !+$
Take off the front and rear covers
(See K1a - K1d)
L2a
L2b
L2c
L2d
Slacken
the
locknuts
Unscrew the
central
screw by
two or three
turns
Tighten
the two
locknuts
L3a
L3b
L3c
Repeat the operation if necessary
M
M1
' -&(-& %.05 0#&$ 0%(22(-&
New fitting.
Take off the front and rear covers and the blade belt, and tip the engine up (See K1a a K1e)
M1a
M1b
M2a M2b
M2c
M2d
M2e
M2f
New fitting.
N
Engine : 1st oil change after 5 hours, then
every 25 hours of use. Check with engine
maintenance manuel enclosed.
Tighten all the nuts on the machine after 5
hours of use. Recheck periodically.
Forward-reverse friction lining : change when
worn by 5 mm (original diameter : 125 mm,
minimum diameter after wear : 120 mm).
' -&(-& 2'$ !+ #$ !0 *$ 1'.$ %2$0
'.30131$
Do not use inflammable solvents to clean the foam insert in the air filter.
O
M2
' -&(-& 0$4$01$&$ 0%(22(-&
Reassembly: Proceed with the reverse operation.
Check regularly whether this
oil is getting dirty, and
change as required
C1
To Next Page
Loading...