MAINTENANCE
A. The machine is equipped with an inner cavity cleaning function: after using it a few
times, please run the heating curve without any components to allow the residual solvent
and solder to evaporate. To ensure the inner cavity is clean and the performance of the
whole machine is stable.
B. Before shutting down the machine, please make sure the machine is cooling down
sufficiently, to prolong the service life of the machine.
C. Regularly clean the observation window in front of the machine to keep it clean.
IV.
ATTENTIONS
1、Please make sure the machine is reliably grounded, and disconnect the machine from
the mains when it is not in use for a long time.
2、The thermal insulation material of the machine has been strictly protected, it is not
allowed to disassemble the machine without protection.
3、Due to technological innovation and product upgrading, etc., if the pictures and
software operations shown in this manual are inconsistent with the real thing, the real thing
shall prevail.
4
、
For more detailed information and technical support, please go and visit the website
www.te168.com for consultation.
To Previous Page
Loading...