12
2.09.21.RH.rev A
1 - BUTTON HEAD SCREW
2 - WASHER
3 - LOCK HANDLE
4 - CASTLE NUT
5 - BASE WASHER (Driver side only)
6 - POST
2
3
4
5
6
1
BUILD THE POST ASSEMBLY
Build the (4) post assemblies used for clamping the hitch to the bed of the truck. Note that the cross pin is factory set.
1. Place the Base Washer down on the Post (Driver side only).
2. Thread Castle Nut onto the Post.
3. Align the Lock Handle 90 degrees to the direction of the Cross Pin and place on top of the Post, the handle cut-out ts
down over the square top on Post.
4. Add the Washer and Button Head Screw and tighten to 4 ft-lbs*.
* WARNING: This screw should be checked for tightness before each use, and also inspect the handle for proper
seating on the post. This will insure that the post assembly will orient properly and safely secure the hitch
to the truck bed.
CROSS PIN
To Next Page
Loading...
