18
2.09.21.RH.rev A
CHALLENGE VS. SOLUTION
CHALLENGE SOLUTION
Cannot open the Release Handle. You may have too much rearward pressure against the lock
mechanism. Back your truck slightly to relieve pressure and set
your parking brake before shifting to park. Continue with the un-
hitching procedures.
The latch handle mechanism seems too sti to
operate.
Spray the locking mechanism with WD-40. Work the handle until
it slides freely. If the problem persists, you may need to degrease
and re-lube all working parts.
I need to have a professional evaluate OE
Series SuperGlide.
Contact PullRite’s Customer Service Dept. at (800) 443-2307.
Your needs will be assessed and resolved by PullRite or you will
be directed to an authorized PullRite Service Center.
Hitch seems loose on the Mounting Posts. You may need to adjust them. Refer to the “Mounting Post
Adjustment” section (page 14).
The Mounting Posts will not rotate into the
“locked” position.
You may need to adjust them. Refer to the “Mounting Post
Adjustment” section (page 14).
NOTE: Most challenging issues can be solved with the use of lubrication such as WD-40 on moving parts (or a
graphite based spray like Slip Plate when the application is metal-to-metal).
To Next Page
Loading...
