Powering On and Image Setting
1.
Open the lens cover (7). The lens cover can be secured to the strap using the built-in
magnet.
2.
Press the ON/OFF (5)button briefly to turn on the device.
3.
Adjust the eyepiece focus ring (1) of the device until the symbols on the display are
sharp.
4.
Rotate the lens focus ring (6) to focus on the object being observed.
5.
Enter the main menu with a long press of the MENU (3) button and select the desired
calibration mode: Manual (M), Semi-Automatic (SA) or Automatic (A).
6.
Calibrate the image by briefly pressing the ON/OFF (5)button.If the SA or A calibration
mode has been selected the microbolometer is closed with an internal shutter
automatically. However, if the M calibration mode has been selected you must close the
lens cover before calibrating manually.
7.
Select the desired observation mode (Forest, Identification, Rocks, User) by briefly
pressing the UP (4) User mode allows you to change and save user defined brightness
and contrast settings in the quick menu.
8.
Enter the main menu with a long press of the MENU (3) button and select the desired
color mode (for more details see the Color Modes section).
9.
Activate the quick menu by briefly pressing the MENU (3) button to adjust the
brightness, contrast and smooth digital zoom (for more details see the Quick Menu
Functions section).
10.
After use, turn the device off by a long press of the ON/OFF (5)
Warning! Never point the lens at intensive energy sources such as laser radiation emitting
devices or the sun. It can damage electronic components in the device. The warranty does not
cover damage arising from failure to comply with operating instructions.
To see the Components and Controls scheme click here.
To Next Page
Loading...
Need help?
General
