www.pulsar.pl EN54M RED POWER plus
8. Technical inspections and maintenance.
Technical inspections and maintenance can be performed after disconnecting the power supply from
the power network. The PSU does not require any specific maintenance, however, its interior should be cleaned
with compressed air if it is used in dusty conditions. In case of fuse replacement, use only compatible
replacement parts.
Technical inspections should be carried out not less frequently than once per year. During the
inspection, check the batteries and run the battery test.
4 weeks after installation, re-tighten all threaded connections (Fig 2 [1,2]).
WEEE MARK
According to the EU WEE Directive – It is required not to dispose of electric or electronic
waste as unsorted municipal waste and to collect such WEEE separately.
CAUTION! The power supply unit is adapted for cooperation with the sealed lead-acid batteries (SLA). After the operation
period they must not be thrown but recycled according to the applicable law.
Pulsar sp.j.
Siedlec 150, 32-744 Łapczyca, Polska
Tel. (+48) 14-610-19-40, Fax. (+48) 14-610-19-50
e-mail: biuro@pulsar.pl, sales@pulsar.pl
http:// www.pulsar.pl, www.zasilacze.pl
To Previous Page
Loading...
Need help?
General