The IMP+
IMP+IMP+
IMP+ can show level, space, distance, on the display. The relays can be
programmed to give an ‘ON’ and ‘OFF’ point for external control. There is
a 4-20 mA output (non isolated in 3 wire mode) that can be connected to a
remote chart recorder or PLC, to monitor level, space or distance, dependant
on the measurement mode selected, and provides a ‘fault condition’ alarm of
either 3.5mA or 22mA.
The IMP+
IMP+IMP+
IMP+ lid has an integral LCD display and 4 buttons which are used for
programming purposes when in Program Mode and as hot keys providing
additional information whilst in Run Mode.
To Next Page
Loading...
