Need help?Do you have a question about the Pulsar IMP+ and is the answer not in the manual?
General| Brand | Pulsar |
|---|---|
| Model | IMP+ |
| Category | Measuring Instruments |
| Language | English |
Specifies the required DC supply voltage range.
Wiring diagram for loop powered operation.
Wiring diagram for source mode operation.
Lists functions for 2-wire and 3-wire terminals.
Steps to enter program mode with passcode.
Explains how to scroll through menus and select options.
Details how to input data for parameters.
Covers Empty Distance, Span, and Blanking.
How to configure and use the analog output.
Options for setting relay function (Not in Use, Alarm, Control).
How to set relays for alarm functions.
How to set ON/OFF points for high and low alarms.
How to set relays for control functions.
How to set ON/OFF points for control functions.
Managing unit access via passcode.
Procedure to set a new passcode.
Restoring all parameters to their original factory settings.
Introduction to application parameters.
Setting the display mode for measurement.
Parameter to define the maximum measurement range.
Setting the basic function of each relay.
Configuring alarm types like Level or Loss of Echo.
Defines the threshold for alarm activation.
Defines the threshold for alarm deactivation.
Sets the relay to operate as a control.
Defines the threshold for control activation.
To Next Page
