To Next Page
S
Sharon DavisJul 31, 2025
What to do if my Pulsar FlowCERT LITE Measuring Instruments display shows an incorrect reading for the current level?
- MMichael JohnsonJul 31, 2025
If your Pulsar Measuring Instruments display is showing an incorrect reading for the current level, measure the actual distance from the transducer head to the surface of the material. Then, enter Program Mode and directly access P21 (Set Distance). Type in the measured distance, press ENTER, and then ENTER again when prompted. Wait until SET is displayed and return to Run Mode; the display should now update to the correct reading.
General
