Page 21
Hot Keys
There are five hot keys on the keypad, which can be used to quickly access
common parameters for viewing only, while in Run Mode. Pressing the hot
key once will display the first parameter, then repeated pressing will display
the others, then the FlowCERT LITE reverts to Run Mode. In program
mode, they have different functions, the functions are shown below.
When application is Flow, view
non-resettable totaliser. View
and reset the resettable totaliser.
Not used with FlowCERT
LITE.
Displays echo confidence, echo
strength, height above loss limit
(H.A.L.L.), average noise, peak
noise or temperature.
Not used with FlowCERT
LITE.
Not used with FlowCERT
LITE.
Reset parameter to default
setting.
Not used with FlowCERT
LITE.
Dependant on application
displays Distance, Level, Space,
Head, Flow or rate of change of
level.
Toggle relay setpoints
between FlowCERT
LITE’s units of measure and
% of span.
Not used with FlowCERT
LITE.
Takes you to the last
parameter edited, when you
first enter program mode.
Gives details of unit type,
software revision and serial
number.
To Next Page
Loading...
