Page 111
Indicator
P872 Fill Indicator
This parameter determines the rate at which the LCD fill indicator activates.
Default = 10m/min
P873 Empty Indicator
This parameter determines the rate at which the LCD empty indicator
activates. Default = 10m/min
Rate
P874 Rate Update
This parameter determines the way in which the rate is calculated. If set to
continuous (P874=0), then the rate is calculated and displayed
continuously, i.e. any change seen from shot to shot is calculated and
displayed, but if set to use values P874=1(Default) then the values set in
P875 and P876 are used to calculate and display the rate.
P875 Rate Time
This parameter is the period (in seconds) over which the material level rate
of change is averaged before the Rate Value (P877) is updated. If the Rate
Distance (P876) is exceeded before the Rate Time (P875) has expired then
the Rate Value (P877) will be updated immediately. Default = 60sec.
P876 Rate Distance
This parameter is the rate Measurement Units (P104) over which the
material level must change before the Rate Value (P877) is updated. If the
Rate Time (P875) expires before the Rate Distance (P876) is exceeded
then the Rate Value (P877) will be updated immediately. Default = 0.05m
P877 Rate Value
This parameter displays the current rate of change of material level, in
Measurement Units (P104) per minute. It is read only.
P878 Lower Cutoff
This parameter is used to select the minimum Rate to be calculated, and can
be used to eliminate unwanted updates from effects of ripples/waves on the
surface of the material.
To Next Page
Loading...
