Need help?Do you have a question about the Pulsar ULTRA Series and is the answer not in the manual?
General| Power Supply | 12-30 V DC |
|---|---|
| Process Temperature | -40°C to +90°C (-40°F to +194°F) |
| Output | 4-20mA, HART |
| Protection | IP68 |
| Resolution | 1 mm |
| Operating Temperature | -40°C to +70°C (-40°F to +158°F) |
| Dimensions | 120 x 120 x 150 mm (aluminum), 120 x 120 x 150 mm (stainless steel) |
Parameter to identify the correct echo in multi-echo situations.
Sets the gain starting point for signal amplitude decay compensation.
Details transducer wiring, junction box connections, and voltage checks for faults.
Guides on interpreting echo profiles for incorrect readings and identifying faults.
Explains causes and solutions for the unit displaying low readings, often due to incorrect empty distance.
Addresses high readings caused by material in flight in the settle zone.
To Next Page
