2
IMP + (FIFTH EDITION REV 1)
April 2021
Part Number M-080-0-005-1P
COPYRIGHT
© Pulsar Measurement, 2005-21. All rights reserved. No part of this publication may be
reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any
language in any form without the written permission of Pulsar Process Measurement Limited.
WARRANTY AND LIABILITY
Pulsar Process Measurement Limited guarantee for a period of 2 years from the date of delivery
that it will either exchange or repair any part of this product returned to Pulsar Process
Measurement Limited if it is found to be defective in material or workmanship, subject to the
defect not being due to unfair wear and tear, misuse, modification or alteration, accident,
misapplication, or negligence.
DISCLAIMER
Pulsar Measurement neither gives nor implies any process guarantee for this product and shall
have no liability in respect of any loss, injury or damage whatsoever arising out of the
application or use of any product or circuit described herein.
Every effort has been made to ensure accuracy of this documentation, but Pulsar Measurement
cannot be held liable for any errors.
Pulsar Measurement operates a policy of constant development and improvement and reserves
the right to amend technical details, as necessary.
The IMP+ shown on the cover of this manual is used for illustrative purposes only and may not
be representative of the actual IMP+ supplied.
CONTACT
For technical support, please contact:
Europe: supporteurope@pulsarmeasurement.com
Outside Europe: supportnorthamerica@pulsarmeasurement.com
If you have any comments or suggestions about this product, please contact:
Europe: europe@pulsarmeasurement.com
Outside Europe: northamerica@pulsarmeasurement.com
Pulsar Measurement website: www.pulsarmeasurement.com
To Next Page
Loading...
