IMP+ INSTRUCTION MANUAL
28
Using the RS232 Serial Interface
The RS232 serial interface is used to communicate between the IMP+, and a
PC using the optional Pulsar IMP PC software, this software is used to obtain
information from the IMP+ so that echo traces can be viewed, parameters
can be uploaded, downloaded, and saved.
To do so, the settings for communications control are set as follows and
cannot be changed: baud rate 19,200, 8 data bits, no parity, 1 stop bits.
Connection between the IMP+ and the PC is made via RJ11 connector
located under the lid of the IMP+.
Important Notice
When connecting to the RS232 (RJ11) port this will cause the IMP+ to draw
20mA, this is necessary to ensure correct operation of the RS232.
To Next Page
Loading...
