How to troubleshoot if my Pulsar Generator engine will not start?
If your Pulsar Generator engine won't start, first, refill the fuel tank. Then, ensure there's enough oil in the engine by adding the recommended oil. Also, check the spark plug, readjust the gap, and dry it or replace it if needed. Finally, clean the fuel sediment cup to ensure fuel is reaching the carburetor.
What to do if there is no electricity at the AC outlets of my Pulsar Generator?
If there's no electricity at the AC outlets of your Pulsar Generator, first, ensure the AC circuit breaker is turned ON. Also, check your electrical appliance or equipment for any defects, replace it or take it to an electrical shop for repair.
General| Model | PG10000B |
|---|---|
| Type | Portable Generator |
| Fuel Type | Gasoline |
| Run Time at 50% Load | 12 Hours |
| Engine Displacement | 420 cc |
| Voltage | 120/240V |
| Wheel Kit | Included |
| Starting Wattage | 10000 Watts |
| Running Wattage | 8000 Watts |
| Engine Type | 4-Stroke |
| Starting System | Electric/Recoil |
| Outlets | 1x 120/240V AC |
| Noise Level | 72 dBA |
To Next Page
