EasyManua.ls Logo

Pulsar PG2000iS - User Manual

Pulsar PG2000iS
30 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Inverter Gasoline
support@pulsar-products.com
OPERATOR’S MANUAL
Model: PG2000iS
Warning: The Engine Exhaust from this product contains chemicals known to
the State of California to cause cancer, birth defects or other reproductive harm.

Table of Contents

Questions and Answers

  • T
    Terry MurphyAug 1, 2025
    What to do if my Pulsar PG2000iS is running but not supplying power?
    • B
      Brandon RodriguezAug 1, 2025
      If your Pulsar Portable Generator runs but doesn't supply power, here's what to check: 1. Ensure the DC Circuit Breaker is in the “ON” position. 2. If the green AC Pilot Light Indicator is off, stop and restart the engine. 3. Inspect and repair any poor connections. 4. Check and repair any defective cord sets. 5. Try connecting a device known to be working properly to rule out issues with the original device. 6. If none of these steps work, there may be a fault in the generator.
  • O
    owenkaraAug 7, 2025
    Why won't my Pulsar PG2000iS Portable Generator start, shuts down, or runs rough?
    • M
      Mrs. Brittany FrancisAug 7, 2025
      If your Pulsar Portable Generator engine won't start, shuts down, or runs rough, consider these possibilities: * Ensure the 3-in-1 switch is not set to “OFF”. Turn the switch to “CHOKE” and pull the recoil starter. * Clean or replace a dirty air filter. * Clean or replace a clogged fuel filter. * Replace stale or absent fuel. * Reconnect a disconnected spark plug wire. * Clean or replace a bad spark plug. * Drain the fuel tank and replace fuel if there is water in the fuel. * Turn off the choke if the engine is overchoked. * Add oil if the oil level is low. * If the engine is flooded, wait 5 minutes and recrank the engine.
  • K
    Karen PattersonAug 13, 2025
    What to do if my Pulsar Portable Generator bogs down when a load is connected?
    • A
      Alicia GomezAug 13, 2025
      If your Pulsar Portable Generator engine runs well without a load but bogs down when loads are connected, consider these potential causes: 1. A short circuit in the connected device. Disconnect the device. 2. The generator is overloaded.
  • J
    Joshua WebbAug 19, 2025
    Why does my Pulsar Portable Generator engine lack power?
    • M
      mariagriffinAug 19, 2025
      If your Pulsar Portable Generator engine lacks power, here are a few things to check: 1. The generator is overloaded. 2. The fuel filter is clogged. Clean or replace the fuel filter. 3. The air filter is dirty. Replace the air filter.
  • A
    Anthony JacobsonAug 25, 2025
    How to fix a Pulsar PG2000iS Portable Generator engine that hunts or falters?
    • M
      Mary WhiteAug 26, 2025
      If your Pulsar Portable Generator engine “hunts” or falters, here's what might be happening: 1. The choke was removed too soon. Move to choke until engine runs evenly.

Summary

Safety Rules and Warnings

General Safety Instructions

General Safety Warnings

Warnings related to wattage, starting/stopping, moving parts, and flammables.

Electrical and Operational Safety

Covers high voltage, grounding, modifications, and proper usage.

Control Panel Functions

Engine Overload Indicator

Ground Terminal Safety

Instructions on how to properly ground the generator for safety.

Generator Assembly Procedures

Connecting to Electrical System

Instructions on connecting the generator to a building's electrical system.

Adding Fuel

Adding and Checking Engine Oil

Procedures for adding and checking the engine oil level.

Generator Operation Guide

Starting the Engine

Detailed steps for starting the generator engine.

Stopping the Engine

Attaching Electronic Devices

Steps for connecting electronic devices to the generator.

Battery Charging Safety

AC Parallel Operation

Parallel Operation Safety

Critical safety warnings for parallel generator operation.

Preventing Overload and Wattage Guide

Guidance on avoiding overload and a reference for device wattages.

Generator Maintenance

Maintenance Schedule Overview

Lists scheduled maintenance tasks based on hours or time intervals.

Spark Plug and Carburetor

Changing Engine Oil

Detailed instructions for draining and refilling the engine oil.

Air Filter Maintenance

Storage and Transportation

Long Term Storage Preparation

Procedure for preparing the engine for extended storage.

Draining Fuel

Troubleshooting Generator Issues

Power Supply Problems

Addresses problems where the generator does not supply power.

Load-Related Performance Issues

Identifies reasons for engine performance issues under load.

Starting and Running Problems

Engine Power and Stability Issues

Wiring Diagrams

120 V System (No Parallel)

120 V System (With Parallel)

Pulsar PG2000iS Specifications

General IconGeneral
AC Voltage120 V
Fuel TypeGasoline
Fuel Tank Capacity1.18 Gallons
Run Time at 50% Load8 hours
Inverter TechnologyYes
Low Oil ShutdownYes
CARB/EPA CompliantYes
TypeInverter
Starting Watts2000W
Rated Power/Running Watts1600W
Max Power/Wattage2000W
DC Output12V
Engine Type4-Stroke OHV
Starting System/MethodRecoil
Outlet Types(2) 120V AC Outlets, (1) 12V DC Outlet
Parallel CapableYes

Related product manuals