12
• Place generator on a level surface.
• Remove screws and then remove the outer casing cover.
CAUTION!
generator. Always check oil level before each operation.
ASSEMBLY
•
• Be sure to replace dipstick and securely tighten before attempting to start the engine.
Insert a funnel into the crankcase dipstick hole and carefully add the specified amount of 4-Cycle engine oil (SAE 10W-
30) to empty reservoir until or oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
• To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick without re-threading.
• Remove the crankcase dipstick.
Recommended Oil: SAE 10W-30
Oil Capacity: 0.35L (11.8oz)
Adding / Check ing Engine O il
To Next Page
Loading...
